MONROmatic  CAA-10
A  TOOL  TO  TEST  THE  MONROE  CAA-10  MANUALLY

PRESENTED AT THE 14th MEETING OF THE
»BBST« = Berlin-Brandenburger-Sammler-Treffen

S O R R Y ,   ALL   » Cxyz «   ARE  BAD  DESIGNED ...
=========================================================
It is not possible to TEST the MONROEmatic CAA manually !
( The knob on the right side has only limited functionality !)
=========================================================

"HOW TO MAKE A TOOL ?"



An ALUMINUM BASE is mounted with the back bottom screws & washers.
For stability a foot is added on its back side.
2 SIDES hold the U-SHAPED UNIT movable on a 4 mm brass pipe axle.
A BELT is made out of a STRIP OF SAND PAPER and mounted over
a BROAD RADIO KNOB and the MOTOR's CENTRIFUGAL SPEED-CONTROL.
The 8 mm ALU-PIPE has 2 HOLES for the 2 SCREWS of the RADIO KNOB.
With this screws the ALU-PIPE and the long inner 6 mm BRASS-PIPE
are fixed together to build the DRIVING AXLE.

Because the centrifugal speed-control is not circular
( it has a horse-shoe shape ! )
the DISTANCE VARIES and had to be made flexible:
The U-SHAPED UNIT CAN TILT on its 4 mm brass axle.
2 TENSION SPRINGS guarantee the permanent FRICTION of the BELT.

On both ends of the 6 mm DRIVING AXLE are THIN RADIO KNOBS
mounted for RIGHT- or LEFT-HANDLING.

How to open the MONROmatic for Repair & Maintenance...
Inside views of the BASIC STATUS ...
Back to the CAA-10 Main Page

impressum:
**************************************************************************
© C.HAMANN        http://public.beuth-hochschule.de/~hamann       02/28/15